10S 36V 37V 15A 18650 Lipo Li-ion Lithium Battery Pack BMS PCB PCM Common Port Circuit Board for Ebike Escooter Electric Bicycle

Description

Product details

Port: Common Port Do not connect the charger or load to P -. It is an invalid port）

It must be charged for a period of time to activate for the first time.

BMS parameter table

❖Charging voltage

10S x 4.2V

❖Discharge current

15A

Peak current

35A

❖Charging current

10A

❖Charging cut-off

Voltage detection: 4.25V ± 0.03V

Voltage release: 4.15V ± 0.03V

Detection delay: 1000mS

❖Discharge cut-off

Voltage detection: 2.8V ± 0.1V

Voltage release: 3.0V ± 0.1V

Detection delay: 1000mS

❖Cell balance

Turn on voltage: NA

Turn off voltage: NA

Balance current: NA

❖Overcurrent cut-off

Voltage detection: NA

Detection delay: 350mS

Release method: disconnect load or charging

❖Short circuit cut-off

External load short circuit

Detection delay: 300uS

Release method: disconnect load or charging

❖Self-consumption

Work power consumption:＜40uA

❖Internal resistance:
＜15mΩ

❖The scope of work:
-40℃/ +80℃

Port: Common Port Do not connect the charger or load to P -. It is an invalid port）
 

It must be charged for a period of time to activate for the first time.

Warm tips

1. Please use it be careful when installing to avoid short circuit.

2. Do not remove or replace the components of the protection board by yourself.

3. Lithium battery protection board with different voltages cannot be mixed. For example, lithium ion BMS cannot be used for Lifepo4.

4. The charge and discharge current cannot exceed the rated value.

5. Please do not change the circuit board .

6. Please use the protective boad within the specified working temperature range and ensure a good heat dissipation environment around the protective board.

7. Design parameters and use conditions must be observed during use because improper use will damage the circuit.